EasyManuals Logo

Ace Heating Solutions Atlas A050 User Manual

Ace Heating Solutions Atlas A050
116 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #92 background imageLoading...
Page #92 background image
92
Rev 2.1
5) If the flame signal is higher than 0.5 Vdc and the flame LED does come on, contact your local Ace Heating
Solutions, LLC. representative for more help.
Figure 6.4. Voltmeter Connected to Control Panel
6-4.4 Gas Valve Leak Test
This test is to check the closure tightness of the gas shutoff valve. It should only be performed by trained, experienced,
flame safeguard technicians during the initial start up of the burner system of whenever the valve is to be replaced. This
test should also be included in the scheduled maintenance and inspection procedures. For the test below, refer to figures
6.6 and 6.7 below.
Petcock
Gas ball-valve
Site-glass
White ceramic s
p
ark rod
Figure 6.2. Atlas Combustion Assembly Without
Burner
Fi
g
ure 6.3. Pilot Assembl
y

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ace Heating Solutions Atlas A050 and is the answer not in the manual?

Ace Heating Solutions Atlas A050 Specifications

General IconGeneral
BrandAce Heating Solutions
ModelAtlas A050
CategoryBoiler
LanguageEnglish