Installation
29
The RAID controller adjustments necessary to use in-band SCSI have been completed.
If an Out-of-Band connection is being used, then it is recommended Peripheral Device Type is set to
No Device (0x7F)
Press *
up
or
down
arrows to select “LUN Application”; and then press <Enter>.
The default setting is “All Undefine LUN.”.
LUN Application-
All Undefine LUN
Press <Enter> and use *
up
or
down
arrows to select “Undefine LUN-0’s.” Applies to ?
Undefine LUN - 0’s
Press <Enter> to accept. The screen should display the following message. LUN Application
Undefine LUN - 0’s
To Next Page
Loading...