Machine Maintenance Procedures 3-13
DIMM (Dual In-line Memory Module) Module Removal 0
Prerequisite:
Base Door Removal
1. Find DIMM (C) on the base assembly (Figure 3-6).
2. Push DIMM clips (A) outwards (Figure 3-9).
3. Remove DIMM from mainboard connector (B) (Figure 3-9).
Figure 3-9. DIMM Modules
4. Repeat steps 2 and 3 for remaining modules.
DIMM Module Installation 0
1. Insert DIMM into mainboard connector (B). Refer to Figure 3-9.
2. Push down on DIMM until module clips (A) lock in position. Refer to Figure 3-9.
3. Repeat steps 2 and 3 for remaining modules.
4. Install Base Door.
To Next Page
Loading...
