3-48 Machine Maintenance Procedures
3. Use the tab (C) to release the LVDS cable from LCD panel connector (D) (Figure 3-47).
Figure 3-47. LVDS Cable
4. Remove the LVDS and camera cable from the LCD panel
.
LVDS and Camera Cable Installation 0
1. Place LVDS and camera cable on the rear of the LCD panel. Refer to Figure 3-45.
2. Adhere the clear mylar tape (B) to secure the camear cable in place. Refer to
Figure 3-47.
3. Use the tab (C) to connect the LVDS cable to the LCD pane connector (D). Refer to
Figure 3-47.
4. Replace the adhesives to secure the LVDS and camera cable in place (Figure 3-45).
5. Install LCD panel.
To Next Page
Loading...
