3-24 Machine Maintenance Procedures
Keyboard Module Installation 0
1. Place the keyboard (E) face down on the keyboard frame (D). Refer to Figure 3-22.
2. Place and align the keyboard bracket with the keyboard. Refer to Figure 3-21.
3. Install and secure fourteen (14) screws to the keyboard bracket. Refer to Figure 3-20.
4. Place the keyboard module (C) face down on the base assembly (Figure 3-19).
5. Connect keyboard FPC (A) to mainboard connector (B). Refer to Figure 3-19.
6. Turn the keyboard module over and align the keyboard module with the the base
assembly. Make sure align it properly to the edge of the system.
7. Install and secure fifteen (15) screws to the keyboard module. Refer to Figure 3-18.
8. Install Palm Rest Cover.
ID Size Quantity Screw Type
Red
Call out
M2.5*6 8
Green
Call out
M2*3 9
Blue
Call out
M2*2 4
Yellow
Call out
ϕ1.6*2.5 NI
8
To Next Page
Loading...
