Machine Maintenance Procedures 3-27
Circuit boards >10 cm² have been highlighted with a yellow rectangle as
shown in Figure 3-26. Remove the circuit board and follow local
regulations for disposal.
Mainboard Installation 0
1. Place the mainboard onto the base assembly. Refer to Figure 3-25.
2. Install and secure two (2) screws (B) to mainboard. Refer to Figure 3-24.
3. Connect DC-in cable to mainboard connector (D) (Figure 3-24).
4. Connect LVDS cable to mainboard connector (C) (Figure 3-24).
5. Connect the speaker cable to mainboard connector (A) on the backside of the
mainboard (Figure 3-23).
6. Install Keyboard Module.
ID Size Quantity Screw Type
BM2.5*6 2
To Next Page
Loading...
