15
Section 5 Meter Setup and Options
With the meter turned off, press and hold for 4 seconds to enter the
Meter Setup mode, shown below.
Press ◄ or ► to display several setup sub-modes:
No. SEt Test number setup. The test number can be set from 1 to 99.
CHE Optical Check mode. Refer to Optical System Check.
SEt System setup, including date, time, test number reset, units,
sound, specimen type and CHD.
PC Data Transfer mode. Refer to Data/Communication.
dEL Memory Delete mode. Refer to Data/Communication.
Elt Exit setup modes and save changes when is pressed.
The meter will automatically return to the Initial Screen.
Press to enter the mode when the desired sub-mode is displayed.
Test Number Setup
From the No. SEt screen, press to enter Test Number Setup.
The test number can be set to any number from 1 to 99.
To Next Page
Loading...