48
Replacing the Batteries
When the battery icon is flashing, the batteries
are low and should be replaced as soon as possible.
An E-4 error message will appear if the batteries are
too low to perform any more tests. The meter will not
function until the batteries are replaced.
Make sure the meter is off before removing the batteries. Turn the meter
over to locate the battery cover. Press the battery cover tab on the top and
lift the cover to open it. Remove and discard the old batteries. Insert four
new AAA batteries into the battery compartment, alternating orientation up
and down as indicated on the bottom of the battery compartment.
Close the battery cover and make sure that it snaps shut. Recheck and
reset the clock setting if necessary, after replacing the batteries to ensure that
the time is correctly set. Refer to Initial Setup.
Note: Do not discard batteries with household waste. Follow local
regulations for disposal.
To Next Page
Loading...
Need help?
General
