23
Self-Testing (Testing with fingertip blood)
Wipe away the first drop of blood. Collect capillary blood (10 μL for individual
test, 35 μL for 3-in-1 test) using a capillary transfer tube or pipette.
When collecting the blood sample into the capillary tube, it is important not to
squeeze the bulb and/or cover the air vent. Holding the tube at a slightly
downward angle, touch the tip of the capillary tube to the blood drop. The
blood will automatically be drawn to the black fill line and stop.
Note: Never squeeze the capillary transfer tube and/or cover the air
vent while collecting the blood sample. Make sure that blood
reaches the black line, or it will be difficult to squeeze the
blood out of the tube.
Align the tip of the capillary transfer tube with the sample application area on
the test device. Squeeze the bulb and cover the air vent to apply the blood
sample to the sample application area (approximately 10 μL for individual test,
35 μL for 3-in-1 test).
Note: Do not touch the test device with the capillary transfer tube or
pipette. The capillary blood should be tested immediately after
collected. Use of a capillary transfer tube or pipette is
recommended for accurate results.
To Next Page
Loading...
Need help?
General
