1-171-17
1-171-17
1-17
Bhapter 1 BIOS SettpBhapter 1 BIOS Settp
Bhapter 1 BIOS SettpBhapter 1 BIOS Settp
Bhapter 1 BIOS Settp
PNP OS Installed No Item Help
Reset Configuration Data Disabled
Resources Controlled By Auto(ESCD) Menu Level
IRQ Resources Press Enter
When resources
PCI/VGA Palette Snoop Disabled are controlled
manually, assign
each system
interrupt a type,
depending on the
type of device
using the
interrupt
←→↑↓: Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit
F1:General Help F5:Previous Values F6:Fail-Safe Defaults
F7:Optimized Defaults
PNP OS Installed
When set to YES, BIOS will only initialize the PnP cards
used for booting(VGA, IDE, SCSI). The rest of the cards
will be initalized by the PnP operating system like
Windows 95. When set to No, BIOS will initialize all the
PnP cards . Therefore for non-PnP operating system
(DOS, Netware), this option must be set to No.
This section describes configuring the PCI bus system. PCI
or Personal Computer Interconnect,is a system which allows
I/O devices to operate at speeds nearing the speed of the
CPU itself when communicating with its own special
components. This section covers some very technical items
and it is strongly recommended that only experienced uses
make any changes to the default settings.
◎◎
◎◎
◎ Figure 7. PnP/PCI Configurations
CMOS Setup Utility-Copyright (C) 1984-2001 Award Software
PnP/PCI Configurations
2.7 2.7
2.7 2.7
2.7
PnP/PCI ConfigurationsPnP/PCI Configurations
PnP/PCI ConfigurationsPnP/PCI Configurations
PnP/PCI Configurations
To Next Page
Loading...
