Installation Guide
7
Step 2: Install the Camera
1. Depending on how you want to install the camera, attach the camera to the bracket through
one of the two (2) holes below or to the hole on the back cover (only in D3x series).
2. Adjust the camera viewing angle and tighten the knob to fix the camera position.
Step 3: Connect the Cables
1. Connect the Ethernet cable from the network side to the Ethernet port of the camera to
complete the installation.
NOTES on using Ethernet cables: For outdoor installations, it is recommended to use
exterior-grade Ethernet cables (CAT5/CAT5e/CAT6); ordinary Ethernet cables are only
To Next Page
Loading...
