Services Blocking
Services blocking is used to prevent a device on the Gateway’s network from
accessing particular services available on the Internet, such as receiving email or
downloading files from FTP sites. To set up services blocking on a
networked device:
1. Click Services Blocking from the menu on the left side of any Advanced
Setup screen. The Services Blocking screen appears.
2. Select the device on which you wish to block services from the Select Device
drop-down list, or enter the device’s IP address in the Enter IP Address text box.
3. Select a service, or multiple services, to block by clicking in the appropriate
check box below Select service to block.
4. Click Apply to save your changes.
5. Repeat steps 1-4 to block services on another device on the Gateway’s network.
The devices that are blocked from accessing services are listed at the bottom of
the screen.
To Next Page
Loading...
Need help?
General
