Operation Manual
CL01-2 Wall Controller
Operation Manual - CL01-2 Wall Controller
Document: 0525-081 Ver. 1 190903
13
09.06.02. Fan Only Operation
1. Make sure the system is Off.
2. For 1-Speed Fan, press the FAN button.
NOTE
If Fan Speed is locked to 1-Speed Fan, CL01-2 will only allow MED speed.
3. For 3-Speed Fan, adjust the Indoor Fan speed (LOW, MED and HIGH) by pressing the FAN button
successively until you reach the desired speed.
NOTE
3-Speed Indoor Fan operation is an optional feature.
IMPORTANT NOTE
When the system is On, the Indoor Fan can run continuously and is indicated by the CONT indicator on
LCD. This is generally preferred during the Cooling Mode to ensure maximum air circulation. However, for
units with optional Outside Air, Indoor Fan operation should be specifically set to satisfy your application
requirements.
09.07. Setting the Clock
The air conditioning system must be turned On before performing these procedures.
1. Press the PROG button 3 times. TIME indicator will be flashing together with the hour field, i.e. 10:00 AM.
2. Press the
or buttons to adjust the hour. AM/PM will adjust after 12.
3. Press the PROG button to enter the hour. TIME indicator will be flashing together with the minute field.
4. Press the
or buttons to adjust the minute.
5. Press the PROG button to enter the minute. Day indicator will be flashing, i.e. MON.
6. Press the
or buttons to adjust the day.
To Next Page
Loading...
