Acura MDX 2014 - Page 62

61
 Routing  Avoided Area
System Setup
5. Rotate i to select a method for
specifying the area. Press u.
The following options are available:
• Address: Specify the general area by entering an address.
2
Address P. 90
• Map Input: Specify the general area by map input.
2 Map Input P. 111
6. If you select Map Input, scroll the
map to position the cursor over
your desired start point, adjusting
the map scale as necessary. Press
u to mark the start point.
 To redo the area selection, press
the BACK button.
7. Scroll the map to “draw” the area.
Press u to mark the end point.
8. Press u to select OK.
 The area you specify is displayed
in the list of areas to avoid.
1 Avoided Area
Avoid area can be set in the 1/20, 1/8, or
1/4 mile map scales.
Cursor
Avoid area