- 35 -
Global Setup (cont.) - Turn-On Input Options
The SSD-66 (5.1) can be programmed to automatically turn on to a specific Input Label or the
last input used. Whether you are turning the SSD-66 (5.1) on through from its front panel, IR
remote, ADA Keypad, touch screen, or a switched AC outlet on some other system compo-
nent, the SSD-66 (5.1) will always turn on to your preprogrammed Input Label. There is even
a setting which will cause the SSD-66 (5.1) to always turn on to the last input used.
Example
If you most frequently view DSS, the SSD-66 (5.1) can be set to always turn on to DSS even
if you last used the CD player.
To program the SSD-66 (5.1)'s "TURNON INPUT", follow these steps.
1 Repeatedly press the SETUP MODE button until the SSD-66 (5.1)'s display reads
"TURNON INPUT".
2 Using the VOL UP or VOL DN buttons, select the "Turn On Input Label" you wish to
use. As you press the VOL UP or VOL DN buttons, you will notice that the SSD-66
(5.1)'s display will advance through all fourteen Input Labels, displaying both their
name and number. Even if you altered an Input Label name, the new name will
appear in the display along with its corresponding Input Label number (1-14). Be-
tween Input Labels 14 and 1, the term "LAST USED" which refers to the SSD-66
(5.1) turning on to the last used input.
3 When the desired Turn On Input Label is displayed in the SSD-66 (5.1)'s window,
press the INPUT SELECT button to exit the SSD-66 (5.1)'s program mode.
At this time, the SSD-66 (5.1) has been programmed to engage to your desired Input Label.
To Next Page
Loading...
