28
| P a g e © Adam Equipment Company 2010
• If the scale shows “x x . x x %”, which is the last weight used as a reference,
press [CE] to clear and use the numeric keypad to enter a new value. Press
[Tare] to accept the new reference weight.
• The weight entered must be greater than 50 scale divisions. ]
• Press [Unit] to return to normal weighing.
NOTE:
The display may jump by large numbers unexpectedly if small weights are used to
set as 100% reference. The scale checks if the weight is too small and will show
Error 7.
To Next Page
Loading...
Need help?
General
