43
| P a g e © Adam Equipment Company 2010
F2 LEd
This parameter sets the LED
indicator to off or on and the
LED type (whether LED’s are
on in the form of a
continuous bar or a spot LED
or a segment of colour).
bAr - Bar type
Spot - Spot type
Seg
-
Segment
oFF - Off
bAr
F3 bEP
This parameter sets the
Beeper to off or on. If set to
on, the beeper can further
be set to sound when the
weighing result is within or
outside the check-weighing
limits.
bP oFF - Off
bP inL - Within limits
bP otL - Outside limits
(>20d)
bP inL
F4 CPS
This parameter allows
setting of a new Check
weighing password, must be
entered twice when asked.
When complete, it will
display “donE”.
To be entered manually.
0000
F5 nCK
This parameter enables
negative check weighing
function with ability to do
negative tare.
on
oFF
on
NOTE:
1. The Check weighing password is separate from the scale password, see
section 13.3.
2. If the password is other than 0000, user must enter the password to gain
access to “F3 LLk”, “F4 LEd”, “F5 bEP”, “F6 CPS” and “F7 nCK”.
To Next Page
Loading...
Need help?
General
