20
7) Once the preprogrammed percentage of extraction (dryness level) is reached, the drying cycle will
end, and the Cycle In Progress portion of the light emitting diode (L.E.D.) display will read COOL
06 MIN REMAIN and dRUM TEMP___F. (FLASH [PL5] must be active for the “dRUM
TEMP” to display. If NFLASH is active then press “ENTER/START” Key to display “dRUM
TEMP.”)
8) Once the Cool Down Cycle is completed, the dryer will shut off, the tone (buzzer) will sound (i.e.,
7-seconds), and the L.E.D. display will read “dONE.” The L.E.D. display will continue to read
“dONE” until the main door is opened.
9) If the Anti-Wrinkle Program is active (on), once the drying cycle and cooling cycles are completed
and the L.E.D. display reads “dONE” the Phase 6 OPL microprocessor controller (computer) will
proceed into the Anti-Wrinkle Program, L.E.D. displays “START GUARd.” If the main door
is not
open within the Anti-Wrinkle Delay Time (i.e., 90-seconds), the basket (tumbler) will rotate (without
heat) for the programmed Anti-Wrinkle On Time (i.e., 20-seconds). The Phase 6 OPL microprocessor
controller (computer) will repeat this process until the programmed Maximum Anti-Wrinkle On
Time has expired (i.e., 10 minutes). The L.E.D. display will read “dONE” until the main door is
opened.
b. Timed (Manual) Dryer Cycle
1) L.E.D. display reads “REAdY” (no cycle in progress).
2) Press Key MANUAL
3) L.E.D. display will now read “dRY TIME 00M.” Enter the drying time desired (from 0 to 99
minutes in one-minute increments). For example, for 40 minutes, press Key “4,” Key “0,” and then
press the “ENTER/START” Key.
4) L.E.D. display will now read “COOL TIME 00M.” Enter cool time desired (from 0 to 99 minutes
in one-minute increments). For example, for 10 minutes, press Key “1,” Key “0,” and then press
the “ENTER/START” Key.
5) L.E.D. display will now read “dRY TEMP F” meaning select Fabric (temperature) desired. Enter
the temperature desired (from 100º F to 200º F in one-degree increments or from 37º C to 93º C in
one-degree increments). For example, for F182, press Key “1,” Key “8,” Key “2,” and then press
the “ENTER/START” Key.
6) For optional reversing models, if the system parameters are set for Select Reverse, the L.E.D.
display will now read “SEL REV” meaning “Select Reverse.” If reversing basket (tumbler) action
is desired, press the “ENTER/START” Key. If No Reverse is desired, press the “0” Key.
7) The dryer will now display “PRESS START” press the “ENTER/START” Key to start the
dryer. The L.E.D. display will read dRYING MANUAL CYCLE, ___MIN REMAIN, dRUM
TEMP___F. (FLASH [PL5] must be active for “dRUM TEMP” to display. If NFLASH is active
then press “ENTER/START” Key to display “dRUM TEMP.”)
To Next Page
Loading...