ADC PHASE 6 OPL - Program Location 2; Program Location 5; Program Location 8; Program Location 0

42
TIME
Program Location 8
No Cycle In Progress
REAdY
PROGRM
8
COOL
0
8
080 F
TEMP
COOL
0 9 0
Continue
Skip to Continue
on page 45.
Display will read "COOL" for 1 second and
"TEMP" for 1 second. If no change, press
"ENTER/START" Key. If a change is
necessary, enter temperature change (70º
to 100ºF in increments of 1ºF). I.e., for
90ºF, press Key "0", Key "9", Key "0", and
then press "ENTER/START" Key.
Display will read "COOL" for 1 second and
"TEMP" for 1 second. If no change, press
"ENTER/START" Key. If a change is
necessary, (0 to 99 minutes in increments of
1 minute). I.e., for 8, press Key "0", Key "8",
and then press "ENTER/START" Key.
To enter program mode, press
"ENTER/START" Key once,
and immediately press the "0" Key
three (3) times within two seconds.
08 M
06 M
090 F
Non-Reversing
Models
Reversing
Models
0 0 0
I
I
I
I
I