ADC PHASE 6 OPL - Automatic Drying Cycle (Patent No. 4,827,627)

30
REAdY
Preprogrammed Cycle Programming
Automatic Drying Cycle (Patent No. 4,827,627)
000
PROGRM
A
(Program Mode)
To enter program mode, press the "ENTER/
START" Key once, and immediately press
the "0" Key three (3) times within two (2)
seconds.
CYCLEA
AUTO
MANUAL
0
AUTO
REV No REV
0 0
No REV REV
Select preprogrammed cycle to be changed (i.e., A).
Display will read "CYCLEA" for 1 second, and
then "AUTO" or "MANUAL". Cycle between
automatic and manual by pressing the "0" Key.
If no change is required press "ENTER/
START" Key.
or
For Non-Reversing models press
"ENTER/START" Key.
Reversing Models:
Display will read "REVERSING" or
"NON-REVERSING" (single
direction rotation). If no change,
press "ENTER/START" Key.
If a change is necessary, press the
"0" Key, and then "ENTER/START"
Key.
Continued
Non-Reversing
Models
Reversing
Models
0
MANUAL
I
I
I
I
I