ADC PHASE 6 OPL - Programming Flowcharts

28
Listed below, is an index of the flowcharts on the following pages.
Flowchart Title Page
Entering and Exiting Program Mode.................................................................................................................. 29
Preprogrammed Cycles:
Automatic Drying Cycle (Patent No. 4,827,627)....................................................................................... 30
Timed (Manual) Drying Cycle ................................................................................................................... 35
System Parameters (Program):
Program Location 2 ................................................................................................................................... 39
Program Location 5 ................................................................................................................................... 41
Program Location 8 ................................................................................................................................... 42
Program Location 0 ................................................................................................................................... 45
Manually Loaded Cycles
Automatic Drying Cycle (Patent No. 4,827,627)....................................................................................... 47
Timed (Manual) Drying Cycle ................................................................................................................... 49
NOTE: To review the preset Program Locations, simply press Key “8” when the light emitting diode
(L.E.D.) display reads “REAdY.”