ADC PHASE 6 OPL - SECTION VII FACTORY PRESET PARAMETERS;PROGRAMS; Parameters for Non-Reversing Dryers

48
Continued
SELREV
0
For Reversing models.
Display will read "select reverse
"
if system parameter is
programmed for select reverse. I
reverse action is desired, pres
s
"ENTER/START" Key. If no
reverse action is desired, pres
s
"0" Key.
Display will read "PRESS
START" and then press
"ENTER/START" Key to
begin the cycle.
Reversing
Models
Non-Reversing Models
or
Reversing Models
set for ALWAYS REVERSE
PRESS START
I
I