ADC PHASE 6 OPL - Page 53

50
1
F
TEMP
dRY
Continued
Display will read "dRY" for 1 second ,
"TEMP" for 1 second, and then F.
Display will read "F" (Fabric/Drying
Temperature). Enter desired drying
temperature (100º to 200ºF in
increments of 1ºF). I.e., for 180ºF,
press Key "1", Key "8", Key "0", and
then press the "ENTER/START"
Key.
F180
0
8
SELREV
0
For Reversing models.
Display will read "select reverse
"
if system parameter is
programmed for select reverse. I
reverse action is desired, pres
s
"ENTER/START" Key. If no
reverse action is desired, pres
s
"0" Key.
PRESS START
Display will read "PRESS
START" and then press
"ENTER/START" Key to
begin the cycle.
Non-Reversing Models
or
Reversing Models
set for ALWAYS REVERSE
Reversing
Models
I
I
I