30
INSTALLATIONCONFIGURATIONOPERATION
FURTHER
INFORMATION
INDEX
THE TRANSMITTERS TAB
The Transmitters tab shows a paginated table of all transmitter devices within the A.I.M.
network.
Click the TRANSMITTERS tab to view the transmitters page.
Transmitters > View Transmitters
The table shows the following information for each transmitter:
• Type (transmitter type)
• Name • Online status
• IP address • Firmware revision of transmitter
• Channels (attributed to each transmitter) • Presets
• Description & Location
• Manage (admin options - see below)
The Manage icons are as follows:
(Note: You can hover your mouse pointer over any icons to reveal additional information):
Congure device: Displays the “Congure Transmitter” page.
Reboot device: Allows you to reboot or reset a unit to its factory settings. A
popup will ask which task you wish to carry out. A reboot is useful if a device enters
an unknown state. A reset will return the unit to its factory default state and reset
its IP address (the unit will retain any rmware updates that have been applied).
Identify unit: Causes the LED lights to ash on the front of the selected unit. An
alert will be shown if the unit cannot be contacted (e.g. if it is ofine).
Delete device: Conrmation will be requested. You will need to factory-reset any
devices that you wish to re-congure to work with A.I.M.
Search lters
The key elds (Name, Description and Location) all provide a
search lter to locate particular items within long lists. Enter a full
or partial search string into the appropriate lter box and then
click to start the search. Optionally use the buttons to
invert the order of the listing.
The page will reload with the same pagination/sort order, but with the added search
lter. It’s possible to lter by several columns at once (e.g. search for all entries with
“mac” in the name, and “mixed” in the description). Search terms are case-insensitive.
You can re-sort and paginate on ltered results without losing the lters.
To remove a lter, click the red cross next to the relevant lter, (you can also empty the
search box and click again).