21
2.4 Electrical Measurement（ADT673 only）
Like pressure measurement, click the main value of the electrical measurement channel to enter the electrical
measurement function setting interface, as shown in Figure 6.
Figure 6 Electrical signal measurement function
◆ It is forbidden to apply current/voltage exceeding the current measuring range to the calibrator;
◆ It can be zeroed by short circuit;
◆ If the measured value exceeds the current range, display will turn red with alarm at the same time;
◆ If the measured value exceeds the measurable range of the calibrator, it will display red "--------" and alarm at the
same time.
To Next Page
Loading...
