Additel 686 - Calibrate Pressure Transmitter

44
(3) Task data can be stored through , in the storage page, user can enter the following information:
Table 21 Save Task
Subject
Valid value
Comment
Name
Letters, numbers, symbols, Chinese
characters
Information for calibration task name
Operator
Letters, numbers, symbols, Chinese
characters
Information for task operator
Calibration date
2000/01/01~2099/12/31
Date of task performing
Ambient humidity
Numbers
Ambient humidity when performing task
Ambient temperature
Numbers
Ambient temperature when performing task
Temperature unit
K、℃、℉
Temperature unit when performing task
Save as
Before adjusting, after adjusting, or
both
Save the data before or after the adjustment, or
both
Note: After saving, return to the task selection page by clicking on at the lower right side.
4.2 Calibrate pressure transmitter
During performing the task, the calibrator can measure and record the current or voltage value output by the
transmitter, so that the whole process can be fully automated.