Effect diagram after assembling
Effect diagram after assembling
3. Screw the M3*3 Locking Screw into the bevel gear (2 sets).
4. Screw the M4*4 Locking Screw into the S12D4 Coupling (2 sets).
3-CH Line Tracking Module+5-Pin wires 1 set
The two plugs of 3-Pin Wires-A are small plugs, 3-Pin Wires-B has a small plug at one
end and a large plug at the other end. To prevent confusion between the following
two components when reading the manual, we define the following two
components as 3-CH WS2812 RGB LED-A and 3-CH WS2812 RGB LED-B.
3-CH WS2812 RGB LED+3-Pin Wires -A 3 sets
Defined 3-CH WS2812 RGB LED-A
Wires are connected to the
input of 3-CH WS2812 RGB LED
(the end marked with a white
strip pattern)
3-CH WS2812 RGB LED+3-Pin Wires -B 1 set
Defined as 3-CH WS2812 RGB LED-B
Assemble the following components
Assemble the following components
To Next Page
Loading...
