ADEEPT PiCar-B - Robot Assembly Guide; Initial Assembly Preparations

www.adeept.com
7
Assemble the following components
Raspberry Pi Camera x1
Raspberry Pi Camera Ribbon x1
Effect diagram after assembling
Assemble the following components
Effect diagram after assembling
2. Assembly
2.1. Preparations before Assembly
1. Connect the Raspberry Pi Camera and the ribbon.
2. Connect the Adeept Ultrasonic Module with 4-Pin wires.
The connection diagrams of the remaining modules and wires are as follows：
Adeept Ultrasonic Module x1
4-Pin wires x1
Adeept RGB LED Module+4-Pin wires 2 sets