ADT BHS-4000A - Disarming the Security System; Disarming and Canceling Accidental Alarms

Turning the System Off
Turning the System Off When No Alarms Are in Progress
1. Enter through a designated entry door. The keypad sounds a tone
to remind you to turn the system off. The ON light blinks.
2. Turn the system off by entering your keypad code.
To prevent an alarm, you must enter your code before the entry
delay ends. See page 12 to reference the Entry Delay Time
programmed in your system.
Once the system is off, the ON light goes out.
1. Enter through a designated entry door. The siren sounds, and the
ON light blinks. The Premium keypad’s message window reads
ALARM. The Standard keypad’s ON light blinks.
2. Enter your keypad code. The Premium keypad’s message window
reads ALARM MEMORY.
3. Press the CANCEL key (you must press the CANCEL key within 20
seconds of entering your code). The keypad beeps.
You will not receive a call from ADT. The Premium keypad’s
message window reads ALARM CANCELED.
Turning the System Off and Canceling an Alarm
Note: If you press the CANCEL key before entering your code, the result is the same.
Should you cause an alarm accidentally:
18
CODE
CODE