Turning the System Off after an Alarm Occurs in Your Absence
If there was an alarm at your house while you were away and the sirens are no longer sounding:
1. Enter the building through a designated entry door. The ON light
blinks. The sirens and speakers are silent. The Premium keypad
shows the numbers of the zones in alarm, and its message window
reads ALARM.
2. Enter your keypad code to turn the system off. The keypad beeps
once every three seconds. The keypad shows the numbers of the
zones that were in alarm. The Premium keypad reads ALARM
MEMORY.
3. Refer to the Pop-Up Zone Card located behind the alarm panel to
verify the location of the zones that were in alarm.
4. To silence the keypad’s beeping and clear alarm memory, press the
CANCEL key.
5. If you do not know what caused the alarm, review the system’s
alarm history at www.MyADT.com or call ADT Customer Care
at 800.445.0872.
20
CODE
To Next Page
Loading...
Need help?
General
