Adtech NCT-04 - Zero Point Switch Installation and Commissioning; Commissioning of Punch Related Signals

NCT-04/03/02 Punch CNC System (Commissioning Manual)
According to the requirement, the minimum resolution should be 0.01mm, and P1.001 X-axis command
multiplier is 1;
P1.002 X axis command division factor: 10
That is, if the system X axis coordinates change 10mm, the system will send 1000 pulses;
0 Note
z When setting the gear ratio, consider the maximum speed and the drive's maximum acceptable pulse
frequency when the controller is running;
For example: a servo pulse port maximum acceptable pulse frequency is 200KHZ; controller's minimum
resolution is 0.001mm
The actual maximum operating speed of the servo is 12m/min; if the feed rate of the controller is set
greater than 12m/min, the motor will accelerate for a period of time and then stop;
z Controller maximum output pulse is 2MHz;
z Controller interpolation maximum output pulse is 500KHz;
2.2.3 Commissioning
After setting up the system and drive gear ratio, check if the gear ratio is set accurately in "metering"
approach;
The specific operation is as follows:
1) Press the
button to switch to "step" mode;
2) Press
/ to switch single-step increment;
3) Manually press "X+", and measure whether the distance traveled by the machine is consistent with the set
single-step increment;
4) If not, reset the gear ratio;
0 Note
Set the gear ratio of other axes in the same method;
2.3 Zero Point Switch Installation and Commissioning
Zero point detection port of X, Y, T, C axis: IN0-IN3;
External zero point detection level; P2.031, P2.032, P2.033, P2.034;
Home direction parameter of each axis: P1.044-P1.047;
Home speed setting: P1.048-P1.051;
Home acceleration setting: P2.067-P2.070;
2.4 Commissioning of Punch Related Signals
Punch signals, including clutch output, feed signal, single punch stopping top dead center, nibbling