Page 30 of 42
3.10.4 Disable – User ID
This operation will cancel the current User ID and return to the default User 1. User 1 can perform
all actions except those defined as programmable (refer to the menu table).
[Disable] User 5 Node 1
ZONE/INPUTS OUTPUTS GROUPS
CONTROLS USER-ID
Press the ÍÎ buttons to highlight the User-ID option and then press the button to select it.
[Disable] User 1 Node 1
ZONE/INPUTS OUTPUTS GROUPS
CONTROLS USER-ID
NOTE: If configured to operate with a timeout and if there has been no user activity after the
programmable period of time (default “No Timeout”), the panel will automatically cancel a User ID
and return the panel to User 1 ID access. This is to ensure that access to restricted options is
automatically cancelled.
3.10.5 Disable – Groups
Disablement Groups are a means of disabling / enabling custom groups of devices. The commands
are command across the network of panels and can be invoked from any panel. The installer will
have configured these groups.
If no groups exist, selection of this option will show a NOT CONFIGURED message.
Some typical examples are:
Stage Smoke Detectors
Floor 2 Sounders
ALL Sounders
The display will show, for example:
[Disable Group] User 5 Node 1
Group Invoke Description
1 . - Stage Smoke Detectors
2 - Floor 2 Sounders
3 - ALL Sounders
Press the ÏÐ buttons to scroll through and highlight the required option and then press the
button to disable it. The display will show that the command has been invoked (activated).
[Disable Group] User 5 Node 1
Group Invoke Description
1 . ok Stage Smoke Detectors
2 - Floor 2 Sounders
3 - ALL Sounders
The GENERAL DISABLE and any specific disable indicators will be illuminated on the panel(s).
To Next Page
Loading...
