Advantech FWA-1112VC - Security Setup

FWA-1112VC_UserManual_Ed1 Copyright 2020 Advantech Co. Ltd. All rights reserved.
Page 73
3.1.19 SECURITY SETUP
“Administrator Password” allows users to configure the system so that a password after
being installed is required each time the system boots, and/or an attempt is made to enter
the Setup program.
Figure 59 Administrator Setup
Note:
 If set the “Password Check” is [Setup], then this only limits access to Setup and is
only asked for when entering Setup.
 If set the “Password Check” is [Always], then this is a power on password and must
be entered to boot or enter Setup. In Setup the User will have Administrator rights.
 The password length must be in the following range:
 Minimum length: 3
 Maximum length: 20