Advantech UNO-2484G V2 - Chapter 4 BIOS Operations; Firmware Update Configuration; Me FW Image Re-Flash

UNO-2484G_V2 User Manual 50
Figure 4.19 OEM Flags Settings
 OEM Flags Settings
Configure OEM flags.
– MEBx Hotkey Pressed
– MEBx Selection Screen
OEMFlag Bit 2: Enable MEBx selection screen with 2 options: press 1 to
enter ME Configuration Screens.
Press 2 to initiate a remote connection.
Note: Network Access must be activated from MEBx Setup for this screen to
be displayed.
– Hide Unconfigure ME Configuration
OEMFlag Bit 6: Hide Unconfigure ME configuration prompt when attempting
ME unconfiguration.
– MEBx OEM Debug Menu Enable
OEMFlag Bit 14: Enable OEM debug menu in MEBx.
– Unconfigure ME
OEMFlag Bit 15: Unconfigure ME with resetting MEBx password to default.
 MEBx Resolution Settings
Resolution settings for MEBx display modes.