CONDOR A22 User Manual
18 | P a g e
2023 All Rights Reserved
V1.2
NEWTON 3 Release
The Newton 3 release is a patented release system, enabling smooth, repeatable results. It uses
both tension as well as a mechanical release to drop the load.
Pressing the Bait release button or RTH button on the remote causes the bait to drop, entering
any of the Fail safes also will cause the bait to drop, before returning home.
The Newton 3 inertia release clip, releases at a fixed load, it is an incredibly safe release system.
If anything causes the line to stop free spooling, the bait will be released as a safety measure.
The Newton clips are set to release at 1.1kg tension. This ensures the Condor drone carrying
capacity and flight stability are kept well within safe limits. Do Not Exceed 450 grams combined
weight of the baited hooks and sinkers.
WARNING: DO NOT ADJUST THE CLIP FOR HIGHER RELEASE PRESSURES. DOING SO
WILL VOID ANY WARRANTY.
1. Battery Indicator Lights
2. Battery On – Off Button
3. Newton 3 Release Clip
4. Battery
5. Rear LED
6. Leg Lock Release Button
7. Front White LED
8. Battery Lock
The release wire connects with one wire loop into the Newton 3 release clip and the other loop
connects to the sinkers and the end of your trace with hooks.
WARNING: ONLY USE THE SUPPLIED RELEASE WIRES.
To Next Page
Loading...
