CONDOR A22 User Manual
22 | P a g e
2023 All Rights Reserved V1.2
Basic Flight Steps
1. Place the Condor in a clear area on smooth ground with the rear LEDs facing you.
(Battery facing you)
2. Power on the remote control and then the UAV, Confirm the mode switch is in P-mode.
3. Wait for the System to warm up to complete, and for status LEDs to flash green.
4. Connect the release wire to your trace and to the Newton 3 release. Lay it out in front of
the UAV.
5. Start the motors, and smoothly push up on the left joystick to make the UAV take off.
6. Climb to your desired height and complete your bait drop.
7. To land, hover over your home point, and gently lower the aircraft onto the ground by
smoothly pulling down on the left joystick.
8. Once on the ground, pull the left-hand joystick down and hold it to shut down the motors.
9. Power the UAV off first, then power off the remote control.
Maintenance
After every flight confirm that the UAV and Remote controller are:
1. Free from any damage
2. Free from any sand
3. Free from any water
Use a soft cloth or brush to clean and dry the UAV and Controller, removing any sand or water.
Not doing so could cause irreparable damage to the UAV or Controller
To Next Page
Loading...
