AERMEC WRC - Set the DISPLAY function on the indoor unit (led and two-figure display)

22
Set the DISPLAY function on the indoor unit (led and two-figure display):
To activate or de-activate illumination of the indoor unit display (obviously except for canalised units), perform the following
operations:
(1) Press the “FUNCTION” key until the icon for this function appears ( ); at this stage, the selected icon will begin to flash,
thereby indicating that the function has been selected;
(2) press the “ENTER/CANCEL” button again to activate the selected function;
(1) (2)
WARNING: to disacvate this funcon,
press the “FUNCTION” buon unl the
funcon to be cancelled is selected and then
press the “ENTER/CANCEL“ buon