P a g e | 28
Complete list of parameters
The table below show the complete list of features.
Change programming password
Change access control password (SMS control of relays, or
non-stored numbers can call intercom & enter code to
activate output 1).
Change monitoring mode password (user can call the
intercom, enter this pass code to listen in and speak)
Store dialling out numbers. (X = button number 1-9 & 0 for
button 10) (Y = number dialled 1-4) (???? = phone number)
Delete a dial out number. (X = button number) (Y = number
position 1-4)
Speaker volume. Where ? = 1-9. 1 = lowest, 9 = highest.
Microphone volume. Where ? = 1-9. 1 = lowest, 9 = highest.
Relay 1 time. ? = seconds, 1-9999
Relay 2 time. ? = seconds, 1-9999.
Calling time for first number, adjust this to avoid voicemail
picking up a call (10-99 secs)
Calling time for second number, adjust this to avoid voicemail
picking up a call (10-99 secs)
Calling time for third number, adjust this to avoid voicemail
picking up a call (10-99 secs)
Talking time. 5-9999 seconds.
Max monitoring time (for listen in mode when calling the
intercom) 00-60 mins. 00 = no limit.
Store a service number to receive a scheduled call or SMS
from the unit. Useful for SIM cards which are not often used
to prevent switch off by the network provider.
Set the time schedule for the intercom to make a scheduled
call or SMS to the service number. 00-60 day time schedule.
00 = no call or SMS.
Choose between making a scheduled call or scheduled SMS.
1 = SMS. 2 = call.
Delete the stored service number
Store caller ID number. Max 14 digits. Only last 6 digits
compared.
To Next Page
Loading...
