Stay ahead. With Agfa Global Services. :Anapurna M4F - Operator Manual
Operations - Changing the parameters 33
N-POINT = Y / N
This enables (Y) or disables (N) the backward feed at the start of your print.
When you print on rigids, you use the media set bar to align the rigid at the
front of the print table. After raising the media set bar, the rigid needs to be
fed backwards in order to be properly aligned with the starting point of the
shuttle.
T = 0
The top margin is the distance that the media will be fed before printing.
Thisvalueissetinmmorinches,accordingtotheunitsthataredenedin
the unit control setting.
R = 0
The R parameter sets the right margin in mm or inches. The right margin is
distance the shuttle goes past the last printed point. This is useful for heat
sensitive media to avoid the lamps sitting over the edges for longer times.
6.3 Media setup. (rigids and roll to roll)
The :Anapurna M4F offers you the choice between handling rigids or roll media. You
can print one or more rigids at the same time or use the automatic winder and un-
winder system for roll fed media.
a. Rigid media.
The media set bar will help you to position the rigids on the printing table. Lower the
media set bar by turning the media
set switch (front or rear side at the
home position). When you use the
media set bar, the n-point and left
margin have to be correctly set.
The two support tables that are de-
livered with the engine, will help
you to process rigid material. The
tables can be locked to the engine
with a clip on system which you
canndontheleftandrightsideof
the tables. Both tables have a width
of 1m60 and are 1m20 long.
You can load rigid media very easily
following the next steps:
IMAGE
When the right margin is
set to e.g. 200mm, the
shuttle will move 200mm
beyond the image.
rigid media
conveyor belt
shuttle
media set bar
Home
Capping
printing zone
N-POINT = Y
backward feed to realign the
media with beginning of the
printing zone
top view :Anapurna M4F
To Next Page
Loading...
