AGFA ANAPURNA M4F - APPENDIX 1. Operator Training Checklist

:Anapurna M4F - Operator Manual Stay ahead. With Agfa Global Services.
56 APPENDIX 1 - Operator training checklist
APPENDIX 1. Operator training checklist.
(Thisdocumentisanoverviewofalltopicsthatshouldbeexplainedclearlybyacertiedengineertoan
operator.Ifalltopicsarechecked,theoperatoriscertiedtoworkwiththe:AnapurnaM4F).
A. INFORMATION.
1. Safety Instructions.
a. Anapurna Engine.
 KnowtheEmergency‘Stop’buttons.
 Makesurethatthe‘SafetySensors’areworking(turned‘ON’).
(While at OFFLINE Mode, Press F4 & then F2).
 Before printing, make sure no one is around the engine.
 Afterprinting,alwaysputtheengineto‘OFFLINE’.
b. UV Light.
 Do not look directly into the UV Light when printing.
 Don’t expose your skin directly to UV light.
 If you need to look at the direction of the light, wear protective glasses.
c. UV Inks.
 UV Inks (and waste) are chemicals, when handling the ink, wear
protective gloves to protect your skin. Also wear protective glasses
to avoid splashes.
 Storage of inks. Ideal between 4° & 10° C. No more than 25° C at any time
 Shelf Life of inks.
 Takecarewhenllingthemaininktank/cleaningtank.
 Keep waste separate from the ink bottles.
 Dispose off waste as per local council regulations.
 Never mix solvent waste or aqueous waste with UV waste (as per local
council regulations).
2. Printer Overview.
a. Terminologies used (Home Side, Purge side or Capping side etc).
b. Anapurna Shuttle (carriage) Layout.
 Print Heads, sub tanks etc.
 2 way ink valves / solution valve.
 UV Lamps.
c. Purge Button (Ink), Flushing Button (Cleaning Solution).
  d. NegativeVacuum‘Gauge’&‘DigitalIndicator’.
e. Ink Supply System.
B. OPERATIONS.
1. Wasatch SoftRIP AE.
a. Wasatch basics.
 Printing Modes (4 pass, 8 pass, bi-dir, uni-dir).
 ImagingCongurations.
 Media Width.
b. Ripping & Printing.
 Supported File formats.
 File preparation: size, scale, crop, mirror, rotate, tiling.
 SelectionofcorrectImagingConguration(printmode).
 Sending to Rip Queue (Or Rip & Print).
2. Anapurna M4F – Start Up Sequence.
a. Compressor & Drier (to get compressed dry air)
b. Exhaust (of the room)
c. Main Switch (Power), Circuit Breakers (if applicable), Power switch.
d. Emergency Buttons on Anapurna Engine.
  e. Power‘ON’(StartButton).
All boxes
should be
checked by
the operator.