Agilent Technologies 1260 Infinity II - TCP;IP parameter configuration

To Next Page

To Previous Page

Agilent 1260 Infinity II Preparative Autosampler User Manual 233

LAN Configuration

TCP/IP parameter configuration

To operate properly in a network environment, the LAN interface must be

configured with valid TCP/IP network parameters. These parameters are:

• IP address

• Subnet Mask

• Default Gateway

The TCP/IP parameters can be configured by the following methods:

• by automatically requesting the parameters from a network-based DHCP

Server (using the so-called Dynamic Host Configuration Protocol). This

mode requires a LAN-onboard Module or a G1369C LAN Interface card, see

“Setup (DHCP)” on page 238

• by manually setting the parameters using Telnet

• by manually setting the parameters using the Local Controller

The LAN interface differentiates between several initialization modes. The

initialization mode (short form ‘init mode’) defines how to determine the

active TCP/IP parameters after power-on. The parameters may be derived

non-volatile memory or initialized with known default values. The

initialization mode is selected by the configuration switch, see Table 17 on

page 235.

Other manuals for Agilent Technologies 1260 Infinity II