Agilent Technologies 1260 Infinity II - Page 239

Agilent 1260 Infinity II Preparative Autosampler User Manual 239
LAN Configuration
13
Dynamic Host Configuration Protocol (DHCP)
3 Turn on the module that hosts the LAN interface.
4 Configure your Control Software (e.g. OpenLAB CDS ChemStation Edition,
Lab Advisor, Firmware Update Tool) and use MAC address as host name,
e.g. 0030d3177321.
The LC system should become visible in the control software (see Note in
section “General Information (DHCP)” on page 237).
Table 2 0 LC Modules with 8-bit configuration switch (B-firmware) (configuration switch
at rear of the instrument)
SW 6SW 7SW 8Initialization Mode
ON OFF OFF DHCP