Setting Up Hardware 1
16900 Series Logic Analysis Systems Installation Guide 17
To connect to a LAN
Local area networks (LAN) are enabled outside of the logic analyzer
application using the Windows network configuration wizard.
1 Connect the LAN cable(s) to the back of your logic analysis system.
• Agilent recommends using a 1 Gbit LAN card when networking
multiple frames.
The 16902B and 16901A frames have an integrated 1 Gbit LAN
interface.
For information on installing a 1 Gbit LAN card in your system, See
“To install interface cards (16900A, 16902A, 16902B, or 16903A)” on
page 115.
• For information on network configurations when connecting multiple
frames see Chapter 5, “Setting Up Multiframe Configurations on
page 85.
2 Refer to “First- Time Set Up” on page 77 to answer the Windows
Welcome when you power up the logic analyzer.
Microsoft recommends the following three steps to ensure the instrument's PC is
protected:
a Use an internet firewall.
b Get computer updates.
c Use up-to-date antivirus software.
To Next Page
Loading...
Need help?
General
