Contents ▲ 304 ▼ Index
If the limit is exceeded, a message appears that prompts you to delete or move the
log file to get free disk space.
– select Auto Run to activate the automatic start of a chip run once the lid of the
Agilent 2100 bioanalyzer is closed and a chip suiting the selected assay is detected.
– select Auto Print to enable the automatic report printing function.
You can now click Settings to display the Autoprint dialog box, where you set the
options for automatic printing after a chip run is complete.
NOTE
The Auto Print settings are independent from those made via the Print command of
the File menu.
4 In the Analysis section, you can activate the Pause Analysis on Setpoint Change
function.
If this function is not active, the measurement results are recalculated every time after
you change a setpoint. If you need to change several setpoints at once, activating this
function saves you time, because the results are only recalculated when leaving the
setpoint explorer or when starting the analysis manually with the start button.
5 In the Graph Signal Color section, click the colored rectangles to the right of the signals.
You can now choose a new color for the selected signal in the Color dialog box.
To Next Page
Loading...
Need help?
General
