Contents ▲ 51 ▼ Index
Selecting an Electrophoretic Assay for a Chip Run
To select an assay:
1 Switch to the Instrument context.
2 In the Tree View Panel, select the bioanalyzer you want to use.
In the upper left of the Instrument tab, an icon shows the status of the bioanalyzer. You
should see one of the following icons (lid open/closed), indicating that the bioanalyzer
is detected by the system:
3 If you do not see one of these icons, check that the bioanalyzer is switched on and
properly connected:
– Check the COM port setting.
– Make sure the bioanalyzer is physically connected to the PC (over the serial
interface).
– Check the power connection.
– Check the power switch.
To Next Page
Loading...
Need help?
General
