Agilent Technologies 240 Series AA - Furnace Instruments Back View; Installation Requirements

Introduction
Agilent 240/280 Series AA (including Zeeman) 33
Furnace instruments back view
Where:
1. Accessories serial port, such as the GTA
Viewing/Fume Extraction Accessory
10. SIPS pump option port
2. USB camera cable port
11. Air purge port
3. AA instrument IEEE 488 cable port
12. GTA 120 power cable
4. AA instrument power cable
13. GTA 120 fuses
5. AA instrument fuse and power setting housing
14. Water in
6. UltrAA lamp option ports
15. Water out
7. C
2
H
2
gas line
16. Alternate gas inlet, typically nitrogen or air
8. Air gas line
17. Normal gas inlet, typically argon
9. N
2
O gas line
18. GTA 120 IEEE 488 cable port
Installation requirements
Before you receive your instrument, you are given an Agilent AA Site Preparation
Guide; which describes the environmental and operating requirements of the
Agilent AA system. Prepare your laboratory according to those instructions before
the Agilent AA can be installed. Keep the Site Preparation Guide for future
reference. If you have misplaced your copy, you can obtain a replacement from
your local Agilent office or the website at www.agilent.com.
1
2
3
5 4
11
6
8 7 9
10
12 13
14
15
16
17
18