Installation
Agilent 240/280 Series AA (including Zeeman) 37
3 Installation
PC requirements 37
Installation procedure overview 38
GPIB communications 38
Connecting and configuring an Agilent AA spectrometer DUO system 39
Configuring the SPS 4 autosampler 41
Configuring the software to use manual sampling 42
USB to RS-232 interfaces 43
Starting the SpectrAA software 44
SpectrAA Release Notes and Software Status Bulletin 44
Installing the drivers for the Tube-CAM Furnace Camera option 45
Printer setup 45
Troubleshooting 45
Service installation module 45
This chapter describes how to prepare your personal computer (PC) and printer
for use with the Agilent AA system and install the SpectrAA software on your PC.
Do not position the equipment or accessories so that it is difficult to operate the
disconnecting device.
PC requirements
If you are supplying your own PC for use with an Agilent AA instrument, the
recommended configurations of that PC are listed in the AA Site Preparation
Guide.
To Next Page
Loading...
Need help?
General
