34410A/11A User’s Guide 95
Remote Interface Configuration 3
Setting up a LAN connection from the Remote Interface
• To enable or disable the LAN remote interface:
SYSTem:COMMunicate:ENABle {OFF>0>ON>1},LAN
• To enable or disable the use of DHCP for the LAN interface:
SYSTem:COMMunicate:LAN:DHCP {OFF>0>ON>1}
• To enable or disable the use of Auto–IP for the LAN interface:
SYSTem:COMMunicate:LAN:AUTOip[STATe] {OFF>0>ON>1}
• To assign the LAN a static IP address:
SYSTem:COMMunicate:LAN:IPADdress <address>
• To assign a LAN Subnet Mask:
SYSTem:COMMunicate:LAN:SMASk <address>
• To assign a LAN Default Gateway:
SYSTem:COMMunicate:LAN:GATEway <address>
• To assign a LAN Host Name:
SYSTem:COMMunicate:LAN:HOSTname “<name>”
• To assign the LAN a static DNS address:
SYSTem:COMMunicate:LAN:DNS <address>
• To assign a LAN Domain Name:
SYSTem:COMMunicate:LAN:DOMain “<name>”
Query forms of these commands are also available. Refer to the Agilent
34410A/34411A Programmer’s Reference for complete command
description and syntax.
To Next Page
Loading...
Need help?
General
