Agilent Technologies 6460 Guide

Exercise 1 – Develop an acquisition method
Task 2. Determine precursor ion masses
12 Agilent 6400 Series Triple Quad LC/MS Familiarization Guide
b Do one of the following:
• Select the example data file
sulfamix01.d, and click Open.
• Select the data file you created in
“Task 1. Enter acquisition
parameters and acquire data” on
page 6, and click Open.
By default, the system displays the
Total Ion Chromatogram (TIC).
• The figure below shows the default
layout.
• The Qualitative Analysis program
displays a newly opened data file
with the same layout and display
settings used for the previous data
file. Therefore, you MUST make
sure to return to the default
settings for this exercise.
Before you begin, make sure that all
previous settings are returned to their
default values:
• Restore default layouts
• Click Configuration > Window
Layouts > Restore Default
Layout.
• Make sure the method is default.m.
(see title bar)
• Click Method > Open.
• Select default.m, and click Open.
• Return display options to default
settings.
• In the Configuration menu, click
each of the Display Options
commands.
• Click Default, and then click OK.
Or...
• Restore the General layout.
• Click Configuration > Configure
for Workflow > General.
• Click OK.
• (optional) Save method changes
if needed.
• Return display options to default
settings.
• In the Configuration menu, click
each of the Display Options
commands.
• Click Default, and then OK.
Steps Detailed Instructions Comments

Agilent Technologies 6460 Specifications

General

Brand	Agilent Technologies
Model	6460
Category	Laboratory Equipment
Language	English