Exercise 2 – Develop a Dynamic MRM method from an MRM acquisition data file or an MRM method
Task 2. Print a report in the Quantitative Analysis program
36 Agilent 6400 Series Triple Quad LC/MS Familiarization Guide
Task 2. Print a report in the Quantitative Analysis program
In this task, you print a report using any template.
You can update a Dynamic MRM method using either a data file or a
quantitation report folder, so this task creates the quantitation report folder.
Steps Detailed Instructions Comments
1 Print a report using the template
MRM_to_DMRM.xltx.
a Click File > Save Batch.
b Click Report > Generate.
The system displays the Generate
Report dialog box.
c Select the Report folder. This folder
name will be used in the next task.
d Select the Report method.
e Click Edit. The Report Method Edit
dialog box opens.
f Click the Results tab. Click Yes
Always generate results file.
g Click Save & Exit.
h Mark All samples.
i Mark All compounds.
j Click OK.
• Copy the MRM_to_DMRM.xltx
template from the \Support\Data
folder on the installation disk.
• For this report, you do not need to
print the report.
• If you have not created a Report
Method, see the online Help for
Quantitative Analysis for
instructions on how to create a
report method.
• The Data Acquisition program uses
the results file in the Quant reports
folder to update the method, so you
must generate this file if you want
to update your method with it.
2 Check the status of the report
using the Queue Viewer program.
a Click Report > Queue Viewer.
b Wait for the report to finish printing.
c Close the Task Queue Viewer
program.
To Next Page
Loading...
Need help?
General
